[section_title title=Closer Look Exterior Cont.]Closer Look Exterior Cont.
On to the back and it is very similar to most cases of this form factor, there is a cutout for the motherboards rear IO, an exhaust fan, 2 x rubber grommet holes for water cooling which are a big bigger than normal, 7 x expansion slots next to an extra vent for airflow and lastly, on the bottom of the case is the cutout for the PSU.
The bottom is home to 4 x feet to help raise the case off the ground to allow for better airflow, especially on carpeted areas. We can also notice 2 x fan filters, one for the PSU and one if users decide to put an extra fan on the inside floor of the VIPER GX.
Taking off the whole front panel reveals room for  2x 120mm fans, or maybe even a 240mm radiator? There is no mention of it in the official specs but I doubt it would be that hard to get one in there with a couple of fans.
Both side panels also have folded handles that can be extended to help make it easier to get them off, once the thumbscrews are undone of course.
[…] I am looking at the Viper GX II which is an updated model of the VIPER GX I previously reviewed. One first look the most noticeable difference is the colour scheme, the […]